Wednesday, February 16, 2022

Wordless Wednesday #386 - NHRR Low Profile Cab DONE!

 




4 comments:

  1. Replies
    1. Thanks Joe! Really appreciate the compliment - especially from they guy that wrote the book (well, article) on how to put these together :^)

      Delete
  2. Nice! For an Atlas or Proto? I have one but mine is not as smooth as yours is. You can make out the print layers. Even after I primed it you can still make them out.

    ReplyDelete
    Replies
    1. Hi Richard and thanks for checking out the blog! This particular cab is for the Atlas model, but I have one for the Proto model too. I think earlier prints were a bit less smooth, but I can attest to the fact that after priming, painting, dullcoting, and weathering, it's harder to see the lines unless you look really closely and bounce the light off them. Good luck and be sure to post your efforts!

      Delete